[Free] 2018(June) Ensurepass Cisco 210-065 Dumps with VCE and PDF 231-240

Ensurepass.com : Ensure you pass the IT Exams
2018 May Cisco Official New Released 210-065
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Video Network Devices v1.0

Question No: 231 – (Topic 5)

A desktop video endpoint is needed that can support a PrecisionHD camera design and a built-in display, and is Bluetooth-ready and multisite-capable. Which desktop endpoint supports all of these requirements?

  1. SX20

  2. EX60

  3. SX80

  4. EX90

Answer: D

Question No: 232 – (Topic 5)

An engineer is configuring mobile and remote access. Which three configuration tasks should the engineer perform? (Choose three.)

  1. Manually configure a Cisco Unified Communications Manager neighbor zone on the Cisco Expressway Core.

  2. Add the Cisco Unified Communications Manager root certificate to the Cisco Expressway Core CTL.

  3. Enable TLS verify mode for the traversal zone.

  4. Add the Cisco Unified Communications domain before enabling services on the Cisco Expressway Core.

  5. Enable H.323 on the Cisco Unified Communications Manager neighbor zone.

  6. Add the Cisco Expressway Edge root certificate to the Cisco Unified Communications Manager CTL.

Answer: B,C,D

Question No: 233 – (Topic 5)

Which codec represents video that is supported by Cisco TelePresence endpoints?

A. H.263 B. H.323 C. H.264 D. H.262

Answer: C

Question No: 234 – (Topic 5)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

An administrator is attempting to register a Cisco TelePresence endpoint to a Cisco VCS. The Cisco VCS uses local authentication and a single username for all endpoints. Where is the first place that the administrator should go to resolve the issue?

  1. VCS gt; Configuration gt; Authentication gt; Devices gt; Local Database

  2. Endpoint gt; Configuration gt; System Configuration gt; Profile 1 gt; Authentication

  3. VCS gt; Configuration gt; Authentication gt; Outbound Connection Credentials

  4. Endpoint gt; Configuration gt; System Configuration gt; SIP gt; Profile 1 gt; Authentication 1

  5. VCS gt; Configuration gt; Registration gt; Allow List

  6. VCS gt; Configuration gt; Registration gt; Deny List

Answer: D

Question No: 235 – (Topic 5)

In this item, you will need to use all information presented to you to successfully answer the question.

Ensurepass 2018 PDF and VCE

Ensurepass 2018 PDF and VCE

Ensurepass 2018 PDF and VCE

Ensurepass 2018 PDF and VCE

The Cisco Telepresence Codec C90 is unable to call the Cisco IP Video Phone. Assuming that the calling search space has been configured correctly, which of these can cause this issue?

  1. The Cisco Telepresence Codec C90 can only be registered to a Cisco Telepresence Video Communication Server.

  2. A multipoint control unit is required in order for the call to work.

  3. The Cisco Telepresence Codec C90 can only be registered as a SIP endpoint to Cisco

    Unified Communications Manager. H.323 is not supported.

  4. URI dialing has not been configured on Cisco Unified Communications Manager.

  5. The Cisco Telepresence Codec C90 Profile 1 gt; CallSetupMode must be configured as a gateway since Cisco Unified Communications Manager does not have a gatekeeper functionality.

  6. The Cisco Telepresence Codec C90 is not registered as a SIP endpoint on Cisco Unified Communications Manager. The Cisco Telepresence Codec C90 needs to be registered as both SIP and H.323.

Answer: E

Question No: 236 – (Topic 5)

A network engineer is installing a Cisco TelePresence MX200 with two microphones in a conference room. How far from each other do the microphones need to be installed?

  1. 1 m

  2. 2 m

  3. 3 m

  4. 4 m

Answer: B

Question No: 237 – (Topic 5)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

An H.323 endpoint that is registered to Cisco VCS Control is not able to make B2B calls. Calls to other internal endpoints are working fine. What is the likely cause of the issue?

  1. The Conductor H.323 zone is set to quot;Off.quot;

  2. The Traversal Zone H.323 zone is set to quot;Off.quot;

  3. The Production CUCM H.323 zone is set to quot;Off.quot;

  4. The Traversal Zone H.323 zone is in a quot;Failedquot; state.

Answer: B

Question No: 238 – (Topic 5)

What is the optimum distance for a person sitting using the Cisco TelePresence System 500?

  1. the camera can adjust automatically

  2. 0.5 meters and 0.75 meters (1.5 and 2.5 feet)

  3. 1.2 meters and 1.8 meters (4 and 6 feet)

  4. 3.0 and 5.0 meters (10 and 15 feet)

Answer: C

Question No: 239 – (Topic 5)

You are checking a DHCP server configuration for video endpoints. What is the role of option 150 in the configuration?

  1. It is the NTP server IPv4 address.

  2. It is not necessary to specify the role of option 150.

  3. It is the TFTP server IPv4 address.

  4. It is the TFTP server IPv6 address.

Answer: C

Question No: 240 – (Topic 5)

Which two of these support an ad-hoc conference call? (Choose two.)

  1. Cisco TelePresence Multiway with Cisco TelePresence Multipoint Control Unit and Cisco TelePresence Video Communications Server

  2. using the Cisco TelePresence Management Suite Scheduler to schedule a conference call to start in 5 minutes

  3. using the Booking tab in the Cisco TelePresence Management Suite to configure a new conference

  4. using the tab Administrative Tools gt; Configuration gt; Conference Settings in the Cisco TelePresence Management Suite

  5. pressing the conference button on a Cisco Unified IP Phone 8941 to conference in a third call

Answer: A,E

100% Ensurepass Free Download!
Download Free Demo:210-065 Demo PDF
100% Ensurepass Free Guaranteed!
210-065 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No